NVX JAD1200.1 Bass Amp & 1/0 Gauge XAPK1d Amplifier Wiring Kit UNBOXING / Pure Copper Wire

Share it with your friends Like

Thanks! Share it with your friends!

Close

Unboxing the NVX JAD1200.1 bass amp and the XAPK1D amp kit! Check Out NVX!
http://www.nvx.com/

Find Yours HERE!
http://www.sonicelectronix.com/

JAD 1200.1 Bass AMP
http://www.nvx.com/car-amplifiers/jad12001.html
Amplifier Series: JAD (NVX)
Amplifier Class: D
Number of Channels: 1 – Mono
Total RMS Power Output
1200 watts
Input Gauge Size: 1/0 AWG
Minimum Impedance Unbridged: 1 ohms
Preamp Outputs
Built-in Crossover
Low-Pass Crossover Frequency: 40 – 320 Hz
Subsonic Filter: 20 – 38 Hz
Signal-to-Noise Ratio: 111 dB
Bass Remote
Fuse Rating
40A x 3
CEA-2006 Compliant
Strappable: Yes

——————

XaPK1D Amp Power Kit
http://www.nvx.com/cables-wires/amplifier-wiring-kits/xapk1d.html
Number of Amplifiers Supported: 2
Power/Ground Wire Size: 1/0 gauge
Power Wire Length: 20 feet
Ground Wire Length: 3 feet
Remote Wire Length: 20 feet
Fuse Holder: ANL/AFS
Fuse Size: 300A
Distribution Block Included
Two with 1/0 gauge input, four 4 gauge outputs
Complies to AWG Standards
OFC (Oxygen-Free Copper)

EXOcontralto
Bassheads Unite 2014

Comments

Write a comment

*********COMPENSATION DISCLOSURE******** Unless otherwise expressly stated, you should assume that the links contained on this site may be affiliate links and the author will earn commission if you click on them and buy the product / service mentioned in this post. We recommend this site to visit Hornby Railways

Many Thanks For Visiting Our Video Blog. ***** Share The Love!

CONTACT US*****DISCLAIMER*****DMCA*****PRIVATE-POLICY*****TERMS